Material quality, there are defects such as clip sew ash, defended cause tool wear fast; Some of the cutting tool edge is not in conformity with the requirements, applicable to different hardness and strength of the parts are also different. Into the line, a knife or into line roller into the line clamping force is insufficient or too tight. At this time, we should adjust the wire feeding knife, make reliable le dao line, change the wire feeding machine wear parts. In order to extend the nail making machine tool using the wire nail machine manufacturers above equipment, we must be prevented from the above aspects.
Because of every working procedure of the nail making machine run normally, so feeding started to pay attention to this step. Nail the opportunity to have a special feeding equipment the sheet will be sent to the specified location, is usually Nail machine manufacturer a vertical hydraulic cylinder position, ready to start production. Feeding is part of mixing materials is another part of blanking of mixing materials processing. To cut large pieces of material into small pieces, it's easy processing; At the same time and clamping process.
Nail making machine can be used to make different kinds of different specifications of the nails, and in order to get perfect products, in addition to equipment, production process, nail making machine price is important, raw material also has a pivotal role. Nail making machine adopted by the basic are all types of steel raw materials, but for the processing of it is not a single, but is composed of a series of complex process, is involved in the production process.
The Angle of the eccentric disc rotating into line, can change the different time into line. Adjust the length of the tie rod, can get the clip wire slide chute in the different locations of the movement. Adjust the thread clamp sliding block in the clip wire slide position, before and after the head of nail can be put into the line mark to adjust or spikes, which can achieve the goal of nail Nail Making Machine manufacturers body not send line mark. Only fully understand the nail making machine equipment into line on how to adjust, the ability to control into line, can also cause no to finished product nail itself into the line mark. In the process of nail making machine equipment production, the question of short service life of cutter, cause the cause of the nail making machine tool break fast as follows.